This isn't my full time job so I'm not trying to support a family or pay the rent with these. As long as I clear a little bit after materials then it's all good. There is some variation because the boxes are customizable, but the standard split box with cotton webbing handle plus clip and hardware, hinges, decorative box corners, clasp and spinning trays is $65. I should also be able to get a clasp with a loop for a lock for the same price. If you don't like the handle there are a couple of other options, but I've tried several and this worked out the best. Brass or nickel package is the same price. The half box is $40, and the full box is $60 since it comes with a less elaborate handle (luggage handle) and only 1 bearing for the single spinning tray.
One of the great things about the trays is the customizability. You can keep them as flat trays, or sink in holes, magnets, steel discs or bolts- or any combination of the above. When you order the box I'll send over a template that you can print out and place your miniatures on to make sure everything fits. You can mark exactly on the template where you want everything and either fax it or email it back. I'll tape that to the tray and get everything exactly where you want it. If thats too complicated you can just describe what you're looking for and I'll put something together for you to use. If you want a customized tray it costs $10-$15 (depending on complexity) plus the cost of the magnets, bolts, or discs, which are very affordable since I buy in bulk. I'm not making money off of the discs or magnets, just covering my cost.
Display bases are going to be variably priced depending on the wood type and complexity of what you want. I'll try and keep some pictures of ones currently for sale on the 'for sale' page. If you want something special let me know and I can get you a price. All display bases come with the hardward pre-set so they can either screw into a bolt or one of the rare-earth magnets with a bolt post as in the picture on the previous page. I do also have a whole bunch of square blocks in oak, poplar, pine and some exotic woods. These inexpensive options will have magnets or discs on top and the hardware on the bottom. That way you can use the whole system without the expense of a custom turned base. The price will depend on the wood and the height but most should be between $4-$10 each.
Pricing on these isn't 100% done but they should be about $1.50 each, which includes the magnet or disc on the bottom. My custom sized bases will be 25mm around the bottom but give a little more room on top and will probably be about the same price.
Main Page is here.
Contact Me if you want one!